Driveline Service of Pittsburgh

Gave them a sheet of paper with the correct measurements as well as a visual diagram to go based off of. Measured the driveshaft on the car twice and then past it onto them. They cut the driveshaft 2 inches to short. When i took it back they had to replace the whole tube and charged me for both services. Will definitely not be bringing my projects back.

I recently had a Dana 60 front axle completely overhauled with new Gear set. The work was fantastic, the axle works perfectly, and the craftsmanship is amazing. Easy to work with, great price points, and genuine care for your parts. In addition, I needed a front driveshaft and did some research, but the owner had more experience than I did and advised me on a solution that was no cost to me...you don't get good honest customer service like that much anymore. These guys are masters at their craft. I'm upgrading to a single piece custom driveshaft and again the work is second to none. All your axle and driveline needs, don't look any further, these guys are BEST

I am swapping an LS engine into my 1984 GM G-body and needed to shorten the driveshaft and replace the front yoke since I am also going with a 4L80E transmission. I took the old driveshaft down and told him the new length I needed. He said he could squeeze it in that day and I came back 1-1/2 hours later and picked it up for a very fair price. You don't get service like that very often these days and I truly appreciated him taking such good care of me and my project vehicle.

Extremely affordable and professional, does awesome work and a very good place to outsource to if necessary. Very friendly staff as well! Our shop needed some axle shaft work done and they had it done within the next business day. Very good workmanship. 10/10

I destroyed my old driveshaft during a race on a Friday night. I called Art on a Friday morning and they had my new driveshaft made in two hours. It held 700 hp leaving on a transbrake with slicks. And the price was so low I gave a $70 tip