Valley Automotive Machine

They did the machine work on a little 250 falcon six for me 4 years ago and it's still running strong! They decided it needed bored it .040" over , turned the crank .010" under and decked the block the amount I needed. I checked my ring gaps and plasti-gauged all the bearing clearances and everything was on the tight end of spec. No complaints at all, they did a great job.

Great work and communication! Tim is always very kind, professional and their work speaks for itself. Everything I have had them machine is to the exact specification I wanted.

Bad customer service. Take it somewhere else. They didn't do the work I paid them for. Took my cylinder head for my boat to this shop, they said they did the work and it was good to go, when I got it back to my mechanic he said it didnt appear as if they did anything but buff out the surface. There was still pitting on the surface head. Verbally he told me he checked the valves as well. My mechanic took it to a different shop who agreed the work was not done. Turns out my valves were bad, as my mechanic suspected. This machine shop hung up on my mechanic when he found out which head he was calling about. When I called the man was very rude, refused to give a refund of any kind. Denied that anything could have been wrong with it, even though I had photo proof of the scratches and pits on th

I run a service department for a truck dealership and have used these fine folks for years, never had anything but quality and honest work from them. Well worth the drive for me to bring my work there.

Tim and his team are top notch. Always meet deadlines and work is on point.